Don’t forget the IPv6 PTR record

Today I learned something :-)

Q: When my Postfix mail server sends an email to a Google recipient, it gets the error message: “The IP address sending this message does not have a PTR record setup, or the corresponding forward DNS entry does not match the sending IP. As a policy, Gmail does not accept messages from IPs with missing PTR records.”

But my server’s IP is 128.140.95.108 and the reverse DNS is set to stewards.mylino.net. And there is an A record for stewards.mylino.net leads to 128.140.95.108. So AFAICS the PTR of my server is correctly configured.

A: By default, Postfix prefers IPv6 when connecting to dual-stack mail servers like Google’s (inet_protocols = all). When you configured your IPv4 address (128.140.95.108), your server’s IPv6 address was likely left without a matching PTR and AAAA record. Every Hetzner Cloud VPS comes with a /64 IPv6 subnet enabled by default, which does not have a reverse DNS (PTR) record configured out of the box.

Solution: Configure also the IPv6 Reverse DNS

Q: Hetzner says that my server’s IP address is 2a01:4f8:c015:4e53::/64 but OVH (where I configure the AAAA record) says that this is not a valid IPv6 address. Why?

A: The string 2a01:4f8:c015:4e53::/64 is a network subnet block, not a single IP address. OVH’s AAAA record requires one specific IPv6 address without the /64 suffix. Hetzner assigns your VPS an entire /64 block of IPv6 addresses (2a01:4f8:c015:4e53::/64), which contains 18 quintillion individual addresses. An AAAA DNS record must point to the single IPv6 address actually bound to your server’s network card, so including /64 causes a validation error.

How to find your exact IPv6 Address?

1. Check your server’s active IPv6 address: Connect to your VPS via SSH and run:

bash ip -6 addr show scope global

The output is something like this:

2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 state UP qlen 1000
    inet6 2a01:4f8:c015:4e53::1/64 scope global
       valid_lft forever preferred_lft forever

Look for the inet6 line on your main interface (eth0 or enp1s0). On Hetzner Cloud, this is almost always 2a01:4f8:c015:4e53::1 (the output shows /64 at the end—do not copy the /64).

Enter it in OVH: Create the AAAA record for stewards.mylino.net using just 2a01:4f8:c015:4e53::1 (or whichever specific address your server showed).

Set the matching PTR in Hetzner: In the Hetzner Cloud Console under Networking, click the three dots next to 2a01:4f8:c015:4e53::/64, select Edit Reverse DNS, and enter the exact same single IP (2a01:4f8:c015:4e53::1) mapped to stewards.mylino.net.

Wednesday, November 18, 2026